|
|
|
This equipment has been tested and found to comply with the limits of a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at their expense.
This equipment has been tested and found to conform to the directives and standards for a Class A Information Technology Equipment type and for the Commercial Light Industrial equipment class.
The VIP-327-PS "MouseFlipper"™ Mouse Format Converters allow a PS/2 mouse to connect to the COM port (serial mouse input) of a PC.
Installation of the VIP-327-PS is exceedingly simple:
1. Connect the PC: Use the DB-9 female/female cable supplied with the unit to connect the Converter connector marked "TO PC COM PORT" to the PC's serial mouse connector (Com port).
2. Connect the Mouse: Use the PS/2 mouse's cable / plug to connect the mouse to the female 6 pin DIN connector of the Converter marked "MSE IN".
3. Connect +5Vdc power source: Connect an external +5Vdc power source to the unit at connector marked "+5VDC IN". Vetra recommends either the VIP-210 (+5Vdc 120Vac 60 Hz) or the VIP-211 (+5Vdc 100 - 240 Vac 50 - 6- HZ). These power supplies can be purchased separately from Vetra or the customer can provide their own power source. If the customer is providing the power source then a PL06 plug (2.5mm x 5.5mm) is to be used, with the center pin wired to +5Vdc (300mA min).
Where possible, the VIP-327-PS Format Converter should be powered up before the PC is powered up. This will insure that the PS/2 mouse receives the correct boot-up commands from the PC. The VIP-327-PS adheres to the IBM Serial Mouse Protocol so the connected PC should have an IBM Serial Mouse Driver associated with the Com Port that the converter is plugged into. Click the link for more detailed information on protocol compatibility.
Copyright© 2000 - 2005 by
Vetra Systems Corporation All Rights Reserved
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
275 Marcus Blvd. Ste-J Hauppauge, NY 11788-2022 USA Toll Free 1-800-537-9296 Tel: 631-434-3185 Fax: 631-434-3516 e-mail: sales@vetra.com |